Jump to content

Search the Community

Showing results for tags '900'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Welcome To Canadian Motorcycle Cruisers
    • CMC Bylaws & Privacy Policy
    • CMC Bylaws & Privacy Policy Copy
  • Announcements & Events
    • Photos & Trip/Event Reports
  • CMC Chapters by Province
  • Making Connections
    • Visit a CMC Chapter Near You
    • Helping Hands - CMC members making a difference
  • Motorcycle Help / Safety & Training
    • Motorcycle Information & Technical Help
  • In Memory
    • In Memory - Gone but not forgotten


  • Community Calendar
  • BC Chapters General Calendar
  • AB Chapters General Calendar
  • 002 Kingston ON
  • 006 Barrie, ON
  • 008 Nanaimo, BC
  • 010 Richibucto, NB
  • 016 Sarnia, ON
  • 017 Windsor, ON
  • 021 Strathroy
  • 024 St Johns, NL
  • 037 Port Alberni, BC
  • 046 Kitchener Waterloo, ON
  • 050 Durham Region, ON
  • 058 Estevan, SK
  • 065 Victoria, BC
  • 071 Mission, BC
  • 072 1000 Islands
  • 082 WestMan, MB
  • 094 Clarington, ON


  • Looking Out The Window
  • In a Crazy CMC World of Alpacas and Goats
  • AcesNEights' Blog
  • Aviation Fuelled Motorcyclist
  • Blog Archive
  • 'Wheelspin' ...Travel Adventures, Tips and Tricks.
  • PRP (Mike)


  • CMC Bylaws
  • CMC Participation Waiver Forms
  • CMC Provincial Chapter List

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...

Found 1 result


    Vulcan 900 WIRING

    Hello all.. I was hoping for an experienced (here is the right answer not a you should be able to answer) I have setup my 2007 Kawasaki Vulcan 900 Custom so that there is a second (accessory) fuse panel under the seat, see pic below. Currently a direct power cable from the battery to a common post on the "new" fuse panel is being used and everything is working just fine... BUT!!! I would like to wire this "new" fuse panel to a "switched" wire, meaning when I turn off my ignition key the power is cut to this "new" fuse panel. I want to make sure all my accessories have no chance of accidentally being left on and draining my battery. Do I need to worry which "switched" wire I tap into? Remember the "switched" wire I am tapping into is going to power a fuse panel with the potential of 6 accessories... currently on 4 are being used with a total fuse amp of 40 amps. (4 X 10amp fuses) Do I also need to put on a relay in between the switched wire and the positive post of the new fuse panel? Thank you. Mike
  • Create New...